Front Panel Controls - Agilent Technologies 6000 Series User Manual

Front Panel Controls

6000 Series Oscilloscope User's Guide
1. Power Switch
Press once to switch power on; press again to
switch power off. See
2. Intensity Control
Rotate clockwise to increase analog
waveform intensity; counterclockwise to decrease. You can vary
the intensity control to bring out signal detail, much like an
analog oscilloscope. Digital channel waveform intensity is not
adjustable. More details about using the Intensity control to
view signal detail are on
3. USB Port
Connect a USB compliant mass storage device to
store or recall oscilloscope setup files or waveforms. You can
also use the USB port to update the oscilloscope's system
software or Quick Help language files if updates are available.
You do not need to take special precautions before removing the
USB mass storage device from the oscilloscope (you do not need
to "eject" it). Simply unplug the USB mass storage device from
the oscilloscope when the file operation is complete. More
information on using the USB port is given in
and Printing Data," starting on page 245.
4. Probe Compensation Terminals
terminals to match each probe's characteristics to the
oscilloscope channel to which it is connected. See
5. Digital Channel Controls
channels on/off, and can be used to select a digital channel for
repositioning on the display. You can press the D15 Thru D0 key
to show the Digital Channel Menu above the softkeys. See
Chapter 3, "Viewing and Measuring Digital Signals," starting on
page 75.
6. Vertical Position Control
channel's vertical position on the display. There is one Vertical
Position control for each channel. See
channels" on page 48.
Front-Panel Controls
page 20.
page 207.
Use the signal at these
These controls switch the digital
Use this knob to change the
"Using the analog
2
Chapter 7, "Saving
page 24.
35