Learn The Front Panel Controls And Connectors - Agilent Technologies InfiniiVision 2000 X-Series User Manual

1
Getting Started
7 Connect probes to all other oscilloscope channels (channel 2 of a
8 Repeat the procedure for each channel.

Learn the Front Panel Controls and Connectors

On the front panel, key refers to any key (button) you can press.
Softkey specifically refers to the six keys that are directly below the
display. The legend for these keys is directly above them, on the display.
Their functions change as you navigate through the oscilloscope's menus.
For the following figure, refer to the numbered descriptions in the table
that follows.
28
If necessary, use a nonmetallic tool (supplied with the probe) to adjust
the trimmer capacitor on the probe for the flattest pulse possible.
On the N2862/63/90 probes, the trimmer capacitor is the yellow
adjustment on the probe tip. On other probes, the trimmer capacitor is
located on the probe BNC connector.
Perfectly compensated
Over compensated
Under compensated
2- channel oscilloscope, or channels 2, 3, and 4 of a 4- channel
oscilloscope).
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide