Alarm Out Setup Screen; Figure 3-26 Alarm Out Screen - Honeywell HRHD 410 User Manual

Configuration
8.
9.
10. Highlight the box beside Transaction Timeout, and set the length of time to wait
11. Highlight the box beside Display Dwell, and set the length of time you would like
12. Highlight the Case Sensitive box and then press the

Alarm Out Setup Screen

Use the Alarm Out setup screen to establish a schedule for each alarm output from the
DVR. Highlight Alarm Out from the Device menu (MENU
then press
Rev 3.03
Highlight the box beside Line Delimiter and press . In the virtual keyboard, enter
the character(s) that the device uses to indicate the end of a line. Control
characters can be created using ^and a capital letter (for example, ^J for NL
[New Line], ^M for CR [Carriage Return]). Refer to the device manufacturer's
documentation for Line Delimiter character(s).
Highlight the box beside Ignore String and then press
keyboard to enter any strings of text that you want the DVR to ignore. Reer to the
device manufacturer's documentation for text strings that the device sends during
transactions, so you will know which ones you do not want recorded.
Note When setting up the EPSON-POS device, the user cannot
change Line Delimiter and Ignore String parameters.
for the new text string. The DVR will consider a transaction ended if there is no text
sting during timeout dwell time after the last text input string. You can adjust the
timeout dwell from 0 to 300 seconds.
to display text-in data. You can adjust the display dwell time from 1 to 300
seconds.
Off. Refer to the device manufacturer's documentation to determine if the text
strings are Case Sensitive. If the device distinguishes between upper and lower
case letters, make certain the Case Sensitive box is turned On.
. The Alarm Out setup screen displays.
Figure 3-26 Alarm Out Screen
40
. Use the virtual
to toggle between On and
➤ ➤
Device Alarm-Out) and
Document 900.0315
02/07