1-Port 100-Ge Plim With Cfp Optics Module - Cisco CRS-1 System Description

1-Port 100-GE PLIM with CFP Optics Module

Table 11: 4-Port 10-GE XFP PLIM LED Descriptions
LED
Status
Port
The 4-port 10-GE XFP PLIM power consumption—74 W (with four optics modules).
The following table provides cabling specifications for the XFP modules that can be installed on the 4-port
10-GE XFP PLIMs.
Table 12: XFP Module Port Cabling Specifications for the 4-Port 10-GE XFP PLIM
Part Number
XFP10GLR-192SR-L,
V01
XFP10GER-192IR-L,
V01
1-Port 100-GE PLIM with CFP Optics Module
The 1-port 100-GE CFP PLIM supports one pluggable CFP optics module.
The 1-port 100-GE PLIM has:
• One port that accepts a CFP optics module
• Status LED for the PLIM
• Four LED indicators for the single port
• The 1-Port 100-GE CFP PLIM power consumption—150 W
The 1-port 100-GE PLIM supports the following types of CFP optical transceiver modules:
• 100-GE pluggable optical transceiver module—CFP-100GE-LR4, V01
Cisco qualifies the optics that are approved for use with its PLIMs.
The following figure shows the front panel of the 1-Port 100-GE CFP PLIM.
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description
62
State Description
Green PLIM is properly seated and operating correctly.
Yellow PLIM has a problem.
Off PLIM is not properly seated or system power is off.
Port is logically active and the laser is on.
On
Off Port is not active.
Description
Low Power multirate XFP
supporting 10GBASE-LR and
OC-192 SR
Low Power multirate XFP
supporting 10GBASE-ER and
OC-192 IR
Line Cards and Physical Layer Interface Modules Overview
Wavelength Fiber Type Typical Maximum
Distance
1310 nm SMF 6.213 miles
(10 km)
1550 nm SMF 24.85 miles
(40 km)