Page 1
At that point you should replace your battery with a new one. That is why we recommend that you keep a spare battery somewhere handy such as the glove compartment DOC.1.00 – November 5, 2003 Gp CA Lp Manufactured in Canada by Autostart...
Table of Contents Table of Contents ... 2 Transmitter Part Number and Serial Number of the Remote Car Starter Module... 3 Introduction... 3 Using the Remote Control ... 3 LCD Remote Functions ... 4 Basic Vehicle Operation ... 4 Alarm Clock ... 4 Time Adjust Mode...
Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation section, later in this Guide, for second-car transmitter functions). The functions of the transmitter are as follows: P. 3 User Guide AS-2510 TW...
(refer to the tables). Countdown Timer This feature allows set up a countdown of a duration entered by the user in hours and minutes using the button (refer to the tables). AS-2510 TW User Guide ( ) button. The START/STOP LOCK but- button P.
Vibration Mode ON and OFF (refer to the tables). Power Saving Mode When set to Power Saving Mode, the Remote Control will cease polling the Remote Starter Module on a regular basis for status information. This will extend battery life. Use the buttons to switch Power Saving Mode ON and OFF (refer to the tables).
TO ENTER COLD WEATHER MODE IN SAFE START MODE TO EXIT COLD WEATHER MODE IN SAFE START MODE AS-2510 TW User Guide ICON BUZZER INSTRUCTIONS /DESCRIPTION Press UNLOCK first and then press the Function MELODY button and the Lock button simultaneously.
Settings for the blower motor (fan), front and rear, as well as heated seats (if equipped) should not be left on . It is recommended to leave the settings on HIGH instead. AS-2510 TW User Guide ICON BUZZER DESCRIPTION 1 Beep...
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni- ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
Valet Mode with the Valet Switch When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being remote-started accidentally.
The Parking Lights will flash 2 times. The Transmitter will BEEP once and the Note: With the Remote Valet activated, the remote starter function will be disabled. Panic Mode Note: Panic Mode can only be activated if the horn has been adequately configured by your installer.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter motor damage that could occur after remote-starting the engine should the user, by force of habit, turn the ignition key to the CRANK AS-2510 TW User Guide button, then button until the Parking Lights flash...
This is to allow a turbocharger to idle down after the user leaves the vehicle. See Turbo Mode section earlier in this Guide. P. 13 Kill. Once Remote button 2 times within 3 seconds to remote- START LOCK button. START User Guide AS-2510 TW Starter UNLOCK...
Always hold the transmitter high, approximately at shoulder height. Holding the transmitter against your chin will also increase your range: your head acts as an antenna. The operating range will be somewhat lower on vehicles equipped with an aftermarket or factory alarm. AS-2510 TW User Guide TRUNK LOCK UNLOCK START : ...
Need help?
Do you have a question about the AS-2510 TW and is the answer not in the manual?
Questions and answers