Table of Contents
Advertisement
T W O - W A Y
AS-2450vTW-FM
A note concerning the battery inside the transmitter:
Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months.
When the battery is low, the transmitter will produce two beeps in a repetitive cycle. At that point
you should replace your battery with a new one. That is why we recommend that you keep a
spare battery somewhere handy such as the glove compartment.
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
DOC: 1.00
- AS-2450vTW-FM -
6 - B U T T O N
T R A N S M I S S I O N
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled
or put into valet mode before servicing.
- September 26, 2007 -
L C D
A U T O M A T I C / M A N U A L
R E M O T E
S T A R T E R
WARNING
- MO -
Assembled in Canada
Advertisement
Table of Contents
Related Manuals for Autostart AS-2450vTW-FM
Summary of Contents for Autostart AS-2450vTW-FM
- Page 1 (Note: Make sure that the automatic vehicle cannot start in "Drive".) 2. It is the user's responsibility to ensure that the remote starter is disabled or put into valet mode before servicing. A note concerning the battery inside the transmitter: Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months.
-
Page 2: Table Of Contents
Remote Trunk Release... 12 Introduction This is a state-of-the-art remote starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features) and the safe start children safety feature. With many an advanced function, this product will satisfy any one of your expectations from high-end commodity and security systems, without neglecting any standard feature commonly offered by entry-level starters. -
Page 3: Using The Transmitter
Using the Transmitter Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with identical remote starters (see Multi-car operation section on page 15). LCD Remote Functions The transmitter offers several command-confirmation and timer features. This section explains some of the key functions available. - Page 4 Button Press for < 1 second Press for > 3 seconds and < 5 seconds Press for > 5 seconds Selecting and adjusting Menu options: When in MENU, press Press button to move up in the menu or Press button to select the option you would like to adjust Press button to increase the value or to activate or deactivate a function or toggle through the selection.
-
Page 5: Parking Countdown
Backlight Color Menu Backlight LCD On Menu LCD on time Clock Menu Clock hour Clock minute Temperature Menu Temperature Language Menu Language Side button Menu F Button Function Menu FB programming Parking Countdown This version of the countdown feature is particularly useful for keeping track of parking meter time: the user may quickly set up the countdown using the 5min before the Parking countdown reaches 0. - Page 6 Time start menu: This feature is used to remote start the car at a pre-programmed time. Once the pre-programmed time is reached, the remote will send a start command to the car module. Secure Remote feature: This feature is used to lock the keypad of the transmitter to avoid accidental button press. When the remote is locked and a button is pressed, the LCD will display “PRESF”...
-
Page 7: Remote-Starting Your Vehicle
Button → L --02 Unlock button car unlock) → L --02 Trunk button(2 car trunk) → L --02 Start button(2 car start) → L --03 Lock button (Channel 1) → L --03 Unlock button (Channel 2) → L --03 Trunk button (Channel 3) →... -
Page 8: Remote Starting
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni- ence store, lock your vehicle and leave it running for the length of a run cycle while you are away. -
Page 9: Valet Modes
— The icon will disappear from your LCD remote if you press Note: With the Ignition valet activated, the remote starter and the alarm function will be disabled. Remote Valet Mode This feature will allow you to remotely put your system into valet mode by using the transmitter instead of the valet button as above. -
Page 10: Panic Mode
— The icon will disappear from your LCD remote. Note: With the remote valet activated, the remote starter and the alarm function will be disabled. Panic Mode In an emergency situation, you can activate panic mode by pressing and holding the button for 3 seconds. -
Page 11: Extended Run Time
Remote Door Locks If your remote starter was installed with the remote door locks option, you will have the convenience of remote keyless entry. See section Arming the Starter Kill, on page 8, for further instructions on remote door locking and unlocking. -
Page 12: Remote Trunk Release
With this added security feature, the system will prevent your vehicle from starting with the ignition key when the starter kill is armed. If your remote starter was installed with the starter kill option, one will not be able to start your vehicle with the key unless the system has been unlocked and disarmed first, or put into valet mode. -
Page 13: Home Valet Tm " Mode
“Home Valet ” Mode If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. Note: Once the home valet mode is activated, the vehicle will not start by remote but the OEM alarm functions will still be enabled. -
Page 14: Engine Run Time
Engine Run Time If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or 25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be programmed to run the engine for 8, 20, or 30 minutes (20 minutes default). -
Page 15: Multi-Car Operation
Once the OEM alarm is activated, it will flash at a slower rate. Multi-car Operation This option allows the owner of two vehicles, both equipped with the same remote starter model, to control both systems with a single remote control. To control the second vehicle: Note: Your remote control must be configured for second car operation by the installer. -
Page 16: Lcd Transmitter Operation And Confirmations (Second Car Control)
LCD Transmitter Operation and Confirmations Basic Operations Function Lock Unlock Start Stop Trunk Start/Stop While in Safe Start Mode Function Button press Start on safe start mode Stop on safe start mode Missing a Start or a Stop Confirmation If you have not received a Start or the Stop confirmation after pressing the button. -
Page 17: Multi-Level Features (Default State)
Multi-Level Features ( The multi-level features allow you to access different features of your vehicle or of a second car by pressing the shift button once, twice or three times. By default, the multi-level features are programmed as follows: Basic Features (press the ... -
Page 18: Troubleshooting Transmitting Range
Level 1 (requires pressing the Level 2 (requires pressing the Level 3 (requires pressing the Level 1 (requires pressing the Level 2 (requires pressing the Level 3 ( requires pressing the Example: If the multi-level features were set to option 3, the setup would be as follows: For “Basic features”: To access the aux. -
Page 19: Diagnostics - Parking Light Flash Table
Diagnostics – Parking Light Flash Table Flashes • Doors locked, starter kill armed. • Run time has expired. • TRUNK button pressed. • Doors unlocked, starter kill disarmed. • Remote start attempt cancelled by remote. • Exiting ignition valet. • Exiting remote valet. 2 slow flashes then •... -
Page 20: Limited Lifetime Warranty
In all cases, the consumer must return the remote starter module to the point of purchase, and must provide a copy of the proof of purchase to said retailer. A remote starter module will be returned to the retailer for the consumer to claim within a 4 (four)-week period.