Programming Options - Autostart AS-2510 TW Installation Manual

Automatic transmission remote starter

Hide thumbs Also See for AS-2510 TW:

User manual (14 pages)

Wiring schematic (1 page)

Table Of Contents

Table of Contents

1. Flash the Hood Pin switch (see Table 1)

– The Parking Lights will stay

– Before the lights go out:

2. Press and hold the Brake Pedal,

– And press one of the following buttons on the Transmitter:

..................to access Mode 1;

LOCK

..............to access Mode 2;

UNLOCK

................to access Mode 3.

TRUNK

The Parking Lights will flash and the horn will honk (if configured) once, twice or

three times to confirm entry into a Mode.

3. Release the Brake Pedal.

Note

The unit will stay in the selected programming

Mode until the Hood Pin-switch or the Brake Pedal

is pressed again. Therefore take your time to

make the proper selection. Pressing the Brake

Pedal will take you back to the Programming

Centre, where you can select a different Mode.

Once you access a particular programming Mode, you will automatically start at Function 1.

Once you select one of the Options of Function 1, you will automatically be taken to the next

Function.

To select one of the four Options of any given Function, press the corresponding button

on the Transmitter:

button .........................to access Option 1

LOCK

button .....................to access Option 2

UNLOCK

button .......................to access Option 3

TRUNK

button .......................to access Option 4

START

In each Function, once an Option has been selected the Parking Lights will flash 1, 2, 3 or 4

times (depending on the selected Option).

Please note that the different Functions within any particular Mode can only be accessed

sequentially: the Programming Centre will move from Function 1 to Function 2, then to

Function 3, and so on. Therefore, whenever you access a particular Mode, be prepared to

re-configure all the Functions of that Mode in ascending order.