Transmitter Part Number and Module Serial Number Transmitter Part Number: ASTR-5614 Transmitter (companion) Part Number: ASTR-LCD1 The installer is to write in the following box the Module’s serial number. Module Serial Number: Introduction This system is a state-of-the-art remote car starter system with command confirmation. It re- presents a major breakthrough in vehicle convenience technology and remote starter systems.
Basic Remote Operation This Unit is equipped with a multi-channel 5-button LCD remote transmitter. It can operate two independent Autostart-equipped vehicles (see Multi-car Operation for 2 car functions). The functions of the transmitter are as follows: Note: Pressing the buttons simultaneously will activate the output.
Alarm Clock The LCD Remote Control has a built-in Alarm Clock which can be set up using the button. Use the buttons to switch the Alarm Clock on and off (refer to the tables). Time Adjust Mode Use Time Adjust Mode to set the current time on your Remote Control using the button (refer to the tables).
OFF mode. ALARM CLOCK MUSIC OR To cycle to the SELECTIONS POWER ON MUSIC SELECTION 5 press of next options 1,2,3,4,5 ALARM CLOCK ADJUST MODE press of (ON/OFF) TIMING COUNT DOWN ADJUST press of MODE (HOUR) AS-2500 TW User Guide...
TIMING COUNT DOWN ADJUST press of MODE (MIN) TIMING COUNT DOWN ENDING SELECTIONS press of MELODY SELECTION 1 1,2,3,4,5 TIMING COUNT DOWN MODE press of (ON/OFF) START COMMAND SELECTIONS press of CONFIRMATION 1,2,3,4,5 Cold Weather Mode FUNCTION BUTTON PRESSED ICON BUZZER INSTRUCTIONS /DESCRIPTION TO ENTER COLD...
START ON simultaneously twice SAFE START MELODY within 3 seconds. Press for MODE 1 sec- a BEEP will be heard- then press 1sec and a melody will be heard again. STOP ON SAFE None MELODY START MODE AS-2500 TW User Guide...
Timing and Alarm Adjustment To apply changes to the hours, minutes melody, etc. you must press and hold the Function button for three (3) seconds after which the hour position will start to flash. To navigate through the options, simply press the Function button until you reach the desired position. Transmitter Finder If the remote is misplaced, the user can locate it by calling it.
Ignition Valet This feature allows the user to enter Valet Mode by using only the Ignition key. It may need to be programmed, please refer to the Options Programming section in the Installation Guide to find out. AS-2500 TW User Guide...
To ENTER Valet Mode 1. With the key in the Ignition switch, turn the key to the and then positions 5 ON (RUN/IGNITION) times within 10 seconds. 2. The Parking Lights will flash 3 times indicating the Module is now in Valet Mode. The LED will turn solid.
3 START/STOP seconds to start the vehicle. This will eliminate accidental remote starts (for example: if there are children playing with the Transmitter). To stop the vehicle, the user must press once. START/STOP AS-2500 TW User Guide P.11...
With this added security feature, the system will prevent your vehicle from starting with the Ignition Key when the Starter Kill is armed. If your Autostart was installed with the Starter Kill option, you will not be able to start your vehicle with the Key unless the system has been unlocked first.
Diagnostics – Parking Lights Flash Rate (Normal Operation) Flashes Description Doors locked, Starter Kill armed. End of Run Time. button pressed TRUNK Start signal received by the Module. Cold Weather Mode cancelled. Cannot start after maximum number of attempts is reached. Remote start attempt cancelled by remote.
Need help?
Do you have a question about the AS-2500 TW and is the answer not in the manual?
Questions and answers