Basic Product Specification - Fujitsu fi-4340C Operator's Manual

Basic Product Specification

1 Scanner Type
2 Image sensor
3 Light source
4 Document Minimum
Size
Maximum
5 Paper Weight
6 Scanning Mono-
Speed chrome
Note (*2)
Color
7 ADF Capacity
8 Optical Resolution
9 Output Res- Binary
olution
Note (*4)
Grayscale
Color
10 Grayscale level (internal)
11 Halftone Patterns
12 Other function
13 Interface
Note (*6)
NOTES
*1: The details are described in Chapter5 "ADF DOCUMENT SPECIFICATION".
*2 ) The scanning speeds given are the maximum mechanical scanning speeds. During actual scanning
some extra time will be required for data transfer and software processing.
*3 ) The maximum number will differ due to the paper thickness. Refer to Chapter5 "ADF DOCUMENT
SPECIFICATION".
*4 ) Maximum output resolution may vary according to the scan size, and setting (simplex/duplex)
*5 ) fi-475CMP3 (JPEG compression board) must be installed.
*6 ) Both SCSI-2 and the Third Party Slot can not be used at the same time.
*7 ) The Power consumption of the boards should be as follows:
- In the Low Power Mode : Less than 0.35 A
- Without IPC-4D(IMAGE PROCESSING CIRCUIT BOARD) : Less than 1.5 A
- With IPC-4D(IMGGE PROCESSING CIRCUIT BOARD) : Less than 3.0 A
G 10-2
ADF (Duplex), Document bed
CCD x 2
White Xenon fluorescent tube x 2
A8 (Portrait)
A4/Letter/Legal
2
52 g/m (14 lb) to 127 g/m
40 pages/min simplex, 80 sides/min duplex
(@200dpi)
34 pages/min simplex, 48 sides/min duplex
(@150dpi)
2
100 sheets (A4, 64 g/m (20 lb))
600 dpi
50 - 800 dpi
50 - 600 dpi
50 - 600 dpi
1024 levels (10 bits)
Dither/Error diffusion
JPEG compression
SCSI-2 (SE)
Third Party Slot
Front/Back
Front/Back
2 Note (*1)
(34 lb)
Note (*3)
Note (*3)
Standard gradient
is 1 dpi, (multiples
are possible)
Standard gradient
is 1 dpi, (multiples
are possible)
Standard gradient
is 1 dpi, (multiples
are possible)
Note (*5)
Shield-type 50 pin
(pin-type) half-
pitch
Note (*7)