Troubleshooting
This chapter describes some potential problems and solutions that may occur when using this scanner.
Should any of the following problems arise, refer to the relevant section listed below.
- Power doesn't turn on.................................... Refer to "Chapter 5-3 Cleaning & Maintenance"
- Operator Panel goes blank ........................... Refer to "Chapter 5-4 Cleaning & Maintenance"
- Scan doesn't start .......................................... Refer to "Chapter 5-5 Cleaning & Maintenance"
- Image or photo scan output is poor ............... Refer to "Chapter 5-7 Cleaning & Maintenance"
- Text or line scan output is poor...................... Refer to "Chapter 5-8 Cleaning & Maintenance"
- Scan image is distorted or unclear ................ Refer to "Chapter 5-9 Cleaning & Maintenance"
- Scan image is striped .................................... Refer to "Chapter 5-10 Cleaning & Maintenance"
- "Check" LED turns on .................................... Refer to "Chapter 5-11 Cleaning & Maintenance"
- "Clean pick roller" LCD message .................. Refer to "Chapter 5-12 Cleaning & Maintenance"
- "Clean ADF glass" LCD message ................ Refer to "Chapter 5-19 Cleaning & Maintenance"
- Frequent double-feeds................................... Refer to "Chapter 5-14 Cleaning & Maintenance"
- Frequent pick-misses..................................... Refer to "Chapter 5-16 Cleaning & Maintenance"
- Frequent paper jams...................................... Refer to "Chapter 5-18 Cleaning & Maintenance"
NOTICE
If the problem cannot be solved, contact your sales or service representative.
G 8-2