Fujitsu fi-4340C Operator's Manual page 91

I
Reading Mode Setting When the VIDEO INTERFACE BOARD is Installed
This section describes the button specifications and setup details for reading modes when the scanner has
the VIDEO INTERFACE BOARD in the third party slot.
When the reading mode is set by the command from the host computer, the following button operation is
not required.
NOTICE
When the VIDEO INTERFACE BOARD is installed in the scanner, the scanner automatically recognizes
the board and changes the display.
Whenever you press
1. Turn the power On and verify that "Scanner Ready" is displayed on the LCD.
Screen M1
2. Press then the scanner displays Screen M2.
Screen M2
3. Press then the scanner displays Screen 1.
Screen 1
4. Select ADF or FB by pressing
Screen 2
5. Select "Simplex" or "Duplex" by pressing
Screen 3.
Screen 3
, the scanner returns to screen M1.
or then press
or
. The scanner displays Screen 2.
. Then press Enter. The scanner displays
G 9-5