Drive Ass'y - Dell 1815 Mono Laser Service Manual

Precautions

5.11 Drive Ass'y

1. Before you remove the Drive Ass'y, you should
remove:
- Rear Cover (Refer to 5.4)
- Side Cover Left (Refer to 5.6.4)
- Shield Controller Ass'y (Refer to 5.10)
2. Remove the five screws securing the Drive Ass'y and
remove it.
Drive Ass'y
Notice : The six screws have numbers stamped into the
Drive Ass'y base plate. When refitting the Drive
Ass'y tighten the screws the order they are
numbered. Only screws numbered 1 to 5 are
fitted at this stage. Screw 6 is fitted when the
Shield Controller Ass'y is refitted.
Service Manual
5-20
3. If necessary, remove the four screws securing the
BVDC Motor Ass'y and remove it.
Harness
Gear Bracket Ass'y
BVDC Motor Ass'y