Dell 1815 Mono Laser Service Manual page 93

Display
Memory Full
Cancel or Start
Memory Full
Divide the Job
No Answer Try Later
No Cartridge
Load Cartridge
No Paper
Add Paper
No such job
Over Heat
Call Service
Open Heat Error Call
Service
Paper Jam 0
Open Front Door
Paper Jam 1
Cartridge Area
Pager Jam 2
Open Rear Door
Power Failure
Data Lost
Printer Error Cycle Power
Ready-toner 0%
TONER EMPTY
Ready-toner 7%
TONER LOW
Scanner locked
Unlock scanner
Self Diagnostic
Waiting for redial
Meaning
The memory is full.
The memory is full.
The remote fax machine has not answered
after several redial attempts.
The toner cartridge is not installed.
The paper in the paper tray has run out.
You are performing an Add/Cancel
operation, but there are no jobs waiting.
There is a problem in the fuser unit.
There is a problem in the fuser unit.
Paper has jammed in the feeding area
of the paper tray.
Paper has jammed in the fuser area.
Paper has jammed in the paper exit area.
The power has been turned of f and then
on and the printer's memory has not been
saved.
A problem has occurred in the Laser
Scanning Unit (LSU).
The toner cartridge is empty.
The toner cartridge is almost empty.
The scanner module is locked.
The engin in your printer is checking
some problems detected.
The machine is waiting for the
programmed interval to automatically
redial.
Alignment & Adjustments
Suggested solutions
Delete unnecessary documents,
retransmit after more memory becomes
available.
Split the transmission into more than
one operation.
Try again. Verify the number to make
sure a fax can be received.
Install the toner cartridge. See
"Installing the Toner Cartridge".
Load paper in the paper tray. See
"Loading Paper".
Check the display to see if there are
any scheduled jobs. The display should
indicate if any scheduled jobs are in
Standby mode, for example, Delay Fax.
Unplug the power cord and plug it back
in. If the problem persists, call for service.
Unplug the power cord and plug it back
in. If the problem persists, call for service.
Clear the jam. See "Paper Feed Jam
(tray 1)" or "Paper Feed Jam (optional
tray 2)".
Clear the jam. See "Fuser Area Jam".
Clear the jam. See "Paper Exit Jam".
The printer's memory was not saved
due to a power failure. The job will
need to be started over.
Unplug the power cord and plug it back
in. If the problem persists, call for service.
Replace the toner cartridge with a new
one. See "Replacing the Toner Cartridge".
Take out the toner cartridge and
thoroughly shake it. By doing this, you
can temporarily reestablish printing
operations.
OR
Replace the toner cartridge with a new
one for the best print quality. See
"Replacing the Toner Cartridge".
Unlock the scanner and press Start.
Please wait a few minutes.
Please wait a few minutes.
Service Manual
6-23