Dell 1815 Mono Laser Service Manual page 50

5.8 ADF Ass'y
1. Before you remove the ADF Ass'y, you should
remove:
- Rear Cover (Refer to 5.4)
- Side Cover (Left, Right) (Refer to 5.6)
- Scanner Ass'y (Refer to 5.7)
2. Release the ADF Harness from the underneath the
Platen Cover Ass'y.
3. Remove the two screws securing the ADF Engine
Ass'y and remove it.
Notice : Take care to thread the ADF Harness through
the Platen Cover Ass'y.
ADF Harness
Platen Cover Ass'y
ADF Engine Ass'y
4. Remove the Open Cover, as shown below.
Open Cover
2
Notice : When working on the ADF Motor Ass'y take
care not to contaminate any of the rubber
surfaces with grease.
5. Release the Bush and rotate it until it reaches the slot,
as shown below. Then lift the Pick Up Ass'y out.
Pick Up Ass'y
2
Precautions
2
1
1
Bushing
Service Manual
5-15