Some Held Jobs Were Not Restored; Supply Needed To Complete Job - Dell B5460dn Mono Laser Printer User Manual

Troubleshooting

Some held jobs were not restored

From the printer control panel, select Continue to clear the message and continue printing.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
•
From the printer control panel, press
•
Unplug the router, then wait for 30 seconds, and then plug it back again.
• Turn off the printer, and then turn it back on.
•
Update the network firmware in the printer or print server. For more information, contact your system support
person.
Standard USB port disabled [56]
Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the USB port.
•
From the printer control panel, set USB Buffer to Auto.

Supply needed to complete job

A supply needed to complete the job is missing. Cancel the current job.
Too many bins attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra bins.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many disks installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra printer hard disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
to confirm.
to clear the message and continue printing.
187