Download  Print this page

Selecting A Location For The Printer - Dell B5460dn Mono Laser Printer User Manual

User's guide.
Hide thumbs


Table of Contents
Learning about the printer
What are you looking for?
Software and Drivers—Certified drivers for my printer and
installers for Dell printer software
Readme files—Last‑minute technical changes, or advanced
technical reference materials for experienced users or
Supplies and accessories for my printer
Replacement cartridges
Safety information for preparing to operate my printer
Regulatory information
Warranty information

Selecting a location for the printer

CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more
trained personnel to lift it safely.
When selecting a location for the printer, leave enough room to open trays, covers, and doors. If you plan to install any
options, then leave enough room for them also. It is important to:
Set up the printer near a properly grounded and easily accessible electrical outlet.
Make sure airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical Committee
156 standard.
Provide a flat, sturdy, and stable surface.
Keep the printer:
Clean, dry, and free of dust.
Away from stray staples and paper clips.
Away from the direct airflow of air conditioners, heaters, or ventilators.
Free from direct sunlight and humidity extremes.
Observe the recommended temperatures and avoid fluctuations:
Ambient temperature 15.6°C – 32.2°C
Storage temperature 10°C – 43.3°C
Allow the following recommended amount of space around the printer for proper ventilation:
Find it here
Software and Documentation CD
Dell Printer Supplies Web
You can purchase printer supplies online, by telephone,
or in select retail stores.
Product Information Guide
Note: The Product Information Guide may not be
available in your country or region.


Table of Contents

   Also See for Dell B5460dn Mono Laser Printer

   Related Manuals for Dell B5460dn Mono Laser Printer

Comments to this Manuals

Symbols: 0
Latest comments: