Smtp Setup Menu - Dell B5460dn Mono Laser Printer User Manual

Understanding printer menus
Use
Parity
Even
Odd
None
Ignore
Honor DSR
On
Off

SMTP Setup menu

Use
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout
5–30
Reply Address
Use SSL
Disabled
Negotiate
Required
SMTP Server Authentication
No authentication required
Login/Plain
CRAM‑MD5
Digest‑MD5
NTLM
Kerberos 5
To
Set the parity for serial input and output data frames.
Note: None is the factory default setting.
Determine whether the printer uses the DSR Signal.
Notes:
•
Off is the factory default setting.
• DSR is a handshaking signal used by most serial cables. The serial port uses
DSR to distinguish data sent by the computer from data created by electrical
noise in the serial cable. The electrical noise can cause stray characters to
print. Set this to On to prevent stray characters from printing.
To
Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
Specify the amount of time in seconds before the server stops trying to
send an e‑mail.
Note: 30 is the factory default setting.
Specify a reply address of up to 128 characters in the e-mail sent by the
printer.
Set the printer to use SSL for increased security when connecting to the
SMTP server.
Notes:
•
Disabled is the factory default setting.
•
When the Negotiate setting is used, the SMTP server determines if
SSL will be used.
Specify the type of user authentication required for printing privileges.
Note: "No authentication required" is the factory default setting.
103