Sensor (Booklet Front Tamper Hp) Late Jam - Lexmark C950 Service Manual

Step Action and questions
Check the bridge drive motor for
5
proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Bridge unit motor.
Does the above component
operate properly?
6 Is the bridge drive motor
properly connected?
Perform a POR.
7
Does the error continue when
the power is turned off/on?
Perform a POR.
8
Does the error continue when
the power is turned off/on?

381.30 Sensor (booklet front tamper HP) late jam

Step Action and questions
Check the booklet unit interface
1
connector assembly.
Is the above component free of
damage?
Check the main connector on the
2
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Check the main connector on the
3
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Check the booklet front tamper by
4
moving it manually.
Does the above component
slide back and forth properly?
Yes
Go to step 7.
Replace the bridge drive motor.
Go to
"Bridge drive motor
removal" on page 4-230.
Replace the bridge unit interface
card assembly.
Replace the finisher PCBA. Go to
"Finisher PCBA removal" on
page 4-281.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
5058-030
No
Go to step 6.
Replace the connection.
Problem resolved
Problem resolved
No
Replace the booklet unit interface
contact.
Replace the booklet sensor
interface cable assembly.
Replace the booklet motor
interface cable assembly.
Remove obstructions.
Diagnostic information
Previous
Next
Go Back
2-159