Finisher Diverter Gate Removal; Finisher Diverter Gate Solenoid Removal - Lexmark C950 Service Manual

Finisher diverter gate removal

Open the finisher front door assembly.
1.
2. Remove the rear upper cover. See
Open the lower pinch guide assembly (A) to the right.
3.
Open the upper pinch guide assembly (B) to the right.
4.
Remove the finisher diverter gate solenoid. See
5.
page 4-275.
Remove the link (C).
6.
Move the finisher diverter gate (D) toward the rear, to the right, and forward, as shown.
7.
B
Front
D
8. Remove the finisher diverter gate (D).

Finisher diverter gate solenoid removal

Open the finisher front door assembly.
1.
2. Remove the rear upper cover. See
Disconnect the connector from the finisher diverter gate solenoid (A).
3.
Release the harness from the clamp.
4.
Remove the two screws securing the bracket (B) to the finisher.
5.
Note: The bracket should not be removed from the finisher, it should be gently moved to provide better
access to the finisher diverter gate solenoid mounting screws.
Remove the two screws securing the finisher diverter gate solenoid (A) to the finisher.
6.
"Rear upper cover removal" on page
"Finisher diverter gate solenoid removal" on
A
"Rear upper cover removal" on page
4-309.
Rear
4-309.
Repair information
5058-030
Previous
Next
Go Back
D
C
4-275