Finisher Right Carriage Belt Removal - Lexmark C950 Service Manual

Remove the two screws securing the finisher docking bracket (D) to the printer.
8.
9. Remove the finisher docking bracket (D).
Reinstallation note: When docking the finisher to the printer, make sure the boss on the finisher docking
bracket (D) is inserted into the hole on the finisher docking latch assembly (C). The finisher should be firmly
locked into position.

Finisher right carriage belt removal

Remove the rear upper cover. See
1.
Remove the finisher front door assembly. See
2.
3. Move the slip clutch gear 24T (A) toward the rear to disengage the stacker bin (B).
Boss
D
"Rear upper cover removal" on page
"Finisher front door assembly removal" on page
C
4-309.
Repair information
5058-030
Previous
Next
Go Back
4-276.
4-285