Lexmark C950 Service Manual page 691

Remove the four screws securing the right panel (C) to the finisher.
6.
C
Remove the media eject motor assembly. See
7.
8. Release the hook of the media eject shaft gear 39T (D) from the eject roll shaft (E).
Remove the media eject shaft gear 39T (D).
9.
Remove the 6 mm bushing (F).
10.
Use a prying tool to remove the e-clip securing the eject roll shaft (E) to the rear of the finisher.
11.
Remove the 8 mm bushing (G).
12.
13. Remove the two e-clips securing the eject roll shaft (E) to the front of the finisher.
Remove the 6 mm bushing (F) and the 8 mm bushing (G).
14.
Move the eject roll shaft toward the rear and outward as shown.
15.
F
D
B
"Media eject motor assembly removal" on page
E
G
G
E-clips
E-clip
F
Front
Rear
A
Rear
)
Repair information
5058-030
Previous
Next
Go Back
4-298.
C
E
4-271