D-Link DGS-3620-52P Reference Manual page 228

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
PIM for IPv6 Global
State
Register Probe Time
(1-127)
Register Suppression
Time (0-65535)
Keepalive Period (120-
65535)
Last Hop SPT
Switchover
Register Checksum
Calculate
Embedded RP State
Click the Apply button to accept the changes made.
PIM for IPv6 Interface Settings
This window is used to configure the settings for the PIM for IPv6 protocol per IP interface.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Interface Settings, as shown below:
Click the Edit button to re-configure the specific entry.
Click the Edit button to see the following window.
Figure 5-93 PIM for IPv6 global Settings window
Description
Click the radio buttons to enable or disable the PIM for IPv6 global state.
Enter the time before the Register-Stop Timer (RST) expires when a DR may send a
Null-Register to the RP to cause it to resend a Register-Stop message.
Enter the period during which a PIM DR stops sending Register-encapsulated data to
the RP after receiving a Register-Stop message.
Enter the period during which the PIM router will maintain (S, G) state in the absence
of explicit (S, G) local membership or (S, G) join messages received to maintain it.
Use the drop-down menu to select the SPT switchover mode on the last-hop switch.
Never - The mode will never switch to SPT. This is the default value.
Immediately - The mode will immediately switch to SPT.
Use the drop-down menu to select the register packet checksum calculating
mechanism.
Not Include Data - When calculate the checksum in IPv6 PIM register packet, the
data portion won't be included.
Include Data - When calculate the checksum in IPv6 PIM register packet, the data
portion will be included.
Use the drop-down menu to enable or disable the embedded RP support in the PIM
for IPv6 state.
Figure 5-874 PIM for IPv6 Interface Settings window
218