Wac Authentication State - D-Link DGS-3620-52P Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
From Port / To Port
Aging Time (1-1440)
State
Idle Time (1-1440)
Block Time (0-300)
Click the Apply button to accept the changes made.

WAC Authentication State

Users can view and delete the hosts for Web authentication.
To view this window, click Security > Web-based Access Control (WAC) > WAC Authentication State as
shown below:
Figure 8-31 WAC Port Settings window
Description
Use the drop-down menus to select a range of ports to be enabled as WAC ports.
This parameter specifies the time period during which an authenticated host will remain
in the authenticated state. Enter a value between 1and 1440 minutes. Tick the Infinite
check box to indicate the authenticated host will never age out on the port. The default
value is 1440 minutes (24 hours).
Use this drop-down menu to enable the configured ports as WAC ports.
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. Enter a value between 1 and 1440 minutes. Tick the Infinite
check box to indicate the Idle state of the authenticated host on the port will never be
checked. The default value is Infinite.
This parameter is the period of time a host will be blocked if it fails to pass
authentication. Enter a value between 0 and 300 seconds. The default value is 60
seconds.
347