D-Link DGS-3620-52P Reference Manual page 494

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Log Message: LCK condition detected. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>, Direction:<mepdirection>,
MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be "inward"
or "outward".
mepid: Represents the MEPID of the MEP.
Event description: LCK condition cleared
Log Message: LCK condition cleared. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>, Direction:<mepdirection>,
MEPID:<mepid>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be "inward"
or "outward".
mepid: Represents the MEPID of the MEP.
Port
Event description: port linkup
Log Message: Port <port> link up, <nway>
Parameters description:
port: Represents the logical port number.
nway: Represents the speed and duplex of link.
Event description: port linkdown
Log Message: Port <port> link down
Parameters description:
port: Represents the logical port number.
BPDU Attack
Event description: BPDU attack happened.
Prevention
Log Message: Port<[unitID:]portNum> enter BPDU under protection state
(mode: drop / block / shutdown)
Parameters description:
unitID: The unit ID.
portNum: The port number.
mode:The BPDU currnt state
Event description: BPDU attack automatically recover.
Log Message: Port <[unitID:]portNum> recover from BPDU under
protection state automatically
Parameters description:
unitID: The unit ID.
portNum: The port number.
Event description: BPDU attack manually recover.
Log Message: Port<[unitID:]portNum> recover from BPDU under
protection state automatically
Parameters description:
unitID: The unit ID.
portNum: The port number.
RIPng
Event description: The RIPng state of interface changed
Log Message: RIPng protocol on interface <intf-name> changed state to
<enabled | disabled>
Informational
484
Notice
Informational
Informational
Informational
Informational
Informational