Ip Multicast Interface Table; Static Multicast Route Settings - D-Link DGS-3620-52P Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Figure 5-8 IP Multicast Forwarding Table window
Enter a Group Address and Network Address, and click Find to search for the information.
Click the View All button to display all the existing entries.

IP Multicast Interface Table

This window displays the current IP multicasting interfaces located on the Switch. To search a specific entry, enter
a multicast interface name into the Interface Name field or choose a Protocol from the pull down list and click Find.
To view the following window, click L3 Features > IP Multicast Interface Table, as shown below:
Figure 5-9 IP Multicast Interface Table window
Enter an Interface Name, select a Protocol, and click Find to search for the information.
Click the View All button to display all the existing entries.

Static Multicast Route Settings

This window is used to create a static multicast route. When an IP multicast packet is received, the source IP
address of the packet normally is used to do the RPF check. When a static multicast route entry is created, if the
source IP address of the received IP multicast packet matches this static multicast route entry, the entry will be
used to RPF check.
To view the following window, click L3 Features > Static Multicast Route Settings, as shown below:
Figure 5-10 Static Multicast Route Settings window
The fields that can be configured are described below:
157