D-Link DGS-3620-52P Reference Manual page 203

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Hello Interval (1-65535)
Dead Interval (1-65535)
Instance ID (0-255)
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.
OSPFv3 Area Aggregation Settings
This window is used to configure the OSPFv3 area aggregation settings.
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Area Aggregation Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Area ID
IPv6 Address/Prefix
Length
Advertise
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the selected entry.
Click the Delete button to remove the selected entry.
OSPFv3 LSDB Table
This window is used to display the OSPFv3 Link State Database (LSDB).
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 LSDB Table, as shown below:
Description
Enter the interval time between the transmissions of OSPFv3 Hello packets, in
seconds. The Hello Interval and Dead Interval should be the same for all routers on
the same link. The default value is 10.
Enter the interval time between the receipts of Hello packets from a neighbor router
before the selected area declares that router down. The Dead Interval must be
evenly divisible by the Hello Interval.
Enter the instance ID of the interface. The default value is 0.
Figure 5-54 OSPFv3 Area Aggregation Settings window
Description
Enter a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain.
Enter the IPv6 network address of the aggregation.
Use the drop-down menu to specify whether the OSPFv3 ABR will use this
aggregation to aggregate the intra-area routes or not.
193