Access Point Mode - D-Link DIR-505L User Manual

Section 4 - Security
Note: To change between Router Mode and Access Point Mode, set the switch on the DIR-505L to the Router/AP setting. Then access the Web UI and
click on Setup at the top, then click on Internet Settings on the left. Select Router or Access Point from the Wireless Mode drop-down list, then click Save
Settings. The DIR-505L will then reboot in the mode you selected.
Wireless
When you are browsing for available wireless
Network Name:
networks, this is the name that will appear in the list
(unless Visibility Status is set to Invisible, see below).
This name is also referred to as the SSID. For security
purposes, it is highly recommended to change from
the default network name.
802.11 Mode:
Select one of the following:
802.11b Only - Select if you are only using 802.11b
wireless clients.
802.11g Only - Select if you are only using 802.11g
wireless clients.
802.11n Only - Select if you are only using 802.11n
wireless clients.
Mixed 802.11g and 802.11b - Select if you are using
a mix of 802.11g and 11b wireless clients.
Mixed 802.11n and 802.11g - Select if you are using
a mix of 802.11n and 11g wireless clients.
Mixed 802.11n, 802.11g and 802.11b - Select if you
are using a mix of 802.11n, 11g, and 11b wireless clients.
Enable Auto The Auto Channel Scan setting can be selected to allow the DIR-505L to choose the channel with the least amount of
Channel Scan:
interference.
Wireless
Indicates the channel setting for the DIR-505L. The channel can be changed to fit the channel setting for an existing wireless
Channel: network or to customize the wireless network. If you enable Auto Channel Scan, this option will be grayed out.
D-Link DIR-505L User Manual

Access Point Mode

48