Configure Wpa/Wpa2 Personal - D-Link DIR-505L User Manual

Section 3 - Configuration
It is recommended to enable encryption on your wireless DIR-505L before your wireless network adapters. Please establish
wireless connectivity before enabling encryption.
1. Log in to the web-based configuration by opening a
web browser and entering the IP address of the repeater
(192.168.0.50). Click on Setup, then click Wireless Settings
on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select WPA only, WPA2 only or Auto (WPA
or WPA2).
4. Next to Cipher Type, select TKIP, AES or TKIP and AES.
5. Next to Pre-Shared Key, enter a key. The key is entered as
a passphrase in ASCII format at both ends of the wireless
connection. The passphrase must be between 8-63 characters.
6. Click Save Settings at the top of the window to save your
changes. If you are configuring the repeater with a wireless
adapter, you will lose connectivity until you enable WPA-PSK
on your adapter and enter the same passphrase as you did
on the DIR-505L.
D-Link DIR-505L User Manual

Configure WPA/WPA2 Personal

106