System - D-Link DIR-505L User Manual

Section 3 - Configuration
Save to Local Use this option to save the current access point
Hard Drive: configuration settings to a file on the hard disk of the
computer you are using. Click the Save button. You will
then see a file dialog where you can select a location and
file name for the settings.
Upload from Use this option to load previously saved access point
Local Hard configuration settings. Click Browse to find a previously
Drive: saved configuration file. Then, click the Upload Settings
button to transfer those settings to the access point.
Restore to This option will restore all configuration settings back
Factory Default: to the settings that were in effect at the time the access
point was shipped from the factory. Any settings that
have not been saved will be lost, including any rules that
you have created. If you want to save the current access
point configuration settings, use the Save button above.
Note: Restoring the factory default settings will not reset the
Wi-Fi Protected Status to "Not Configured. "
Reboot the Click to reboot the access point.
Device:
Remove
Click to remove any installed language packs.
Language Pack
D-Link DIR-505L User Manual

System

135