Configure Wpa/Wpa2 Personal - D-Link DIR-505L User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless DIR-505L
before your wireless network adapters. Please establish wireless
connectivity before enabling encryption.
1. Log in to the web-based configuration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Setup, then click Wireless Settings on the left side, and click on
Manual Wireless Network Setup.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select WPA only, WPA2 only or Auto (WPA
or WPA2).
4. Next to Cipher Type, select TKIP, AES or TKIP and AES.
5. Next to Pre-Shared Key, enter a key. The key is entered as a
passphrase in ASCII format at both ends of the wireless connection.
The passphrase must be between 8-63 characters.
6. Click Save Settings at the top of the window to save your changes.
If you are configuring the router with a wireless adapter, you will
lose connectivity until you enable WPA-PSK on your adapter and
enter the same passphrase as you did on the DIR-505L.
D-Link DIR-505L User Manual

Configure WPA/WPA2 Personal

51