When You Cannot Print - Ricoh Aficio MP 7001 Troubleshooting Manual

When You Cannot Print

This section describes what to do if printing does not start even after performing [Print].
Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Cause
The power is off.
The machine is set to
"Offline".
The cause is displayed on the
display of the control panel.
The interface cable is not
connected correctly.
The correct interface cable is
not being used.
The interface cable was
connected after the machine
was switched on.
If the machine is using
wireless LAN, failure to print
might result from a weak
wireless signal.
When You Cannot Print
Solution
Check the cable is securely plugged into
the power outlet and the machine. Turn
on the main power switch.
Press [ Online].
Check the error message or warning
status on the display panel and take the
required action.
Connect the interface cable securely. If
it has a fastener, fasten that securely as
well. See "Connecting to the Interfaces",
Network and System Settings Guide
.
The type of interface cable you should
use depends on the computer. Be sure to
use the correct one. If the cable is
damaged or worn, replace it. See
"Connecting to the Interfaces", Network
and System Settings Guide
Connect the interface cable before
turning on the machine.
In [System Settings], under [Interface
Settings], select [Wireless LAN], and
then press [Wireless LAN Signal] to
check signal status. If signal quality is
poor, move the machine to a location
where radio waves can pass or remove
objects that might cause interference.
(You can check signal status only when
using wireless LAN in the infrastructure
mode.)
4
.
87