2. Troubleshooting When Using the Copy/Document Server Function
When You Cannot Make Clear Copies
This section describes likely causes of and possible solutions for unclear copies.
Problem
2
Copies appear dirty.
Copies appear dirty.
The reverse side of an original
image is copied.
The reverse side of an original
image is copied.
The reverse side of an original
image is copied.
A shadow appears on copies
if you use pasted originals.
The same copy area is dirty
whenever making copies.
32
Cause
Image density is too high.
Auto Image Density is not
selected.
Image density is too high.
Auto Image Density is not
selected.
The original is thin.
Image density is too high.
The exposure glass, scanning
glass, or ADF is dirty.
Solution
Adjust the image density settings. See
"Adjusting Copy Image Density", Copy
and Document Server Reference
On the control panel, select [Auto
Density].
Adjust the image density settings. See
"Adjusting Copy Image Density", Copy
and Document Server Reference
On the control panel, select [Auto
Density].
On the control panel, select [Auto
Density], or adjust the image density
settings.
See "Adjusting Copy Image Density",
Copy and Document Server Reference
.
• Adjust the image density settings.
See "Adjusting Copy Image
Density", Copy and Document
Server Reference
• Change the orientation of the
original.
• Put mending tape on the pasted
part.
Clean them. See "Maintaining Your
Machine", About This Machine
.
.
.
.