Dell C3765dnf Color Laser Printer User Manual page 63

WPS-PBC
You can start Push Button Control only from the operator panel.
NOTE:
WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required
for wireless configuration by pressing the button provided on the access point via wireless routers, and then performing WPS-
PBC setting on the operator panel. This setting is available only when the access point supports WPS.
NOTE:
Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access
point. For information about WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless
LAN access point.
1 Press the
(Information) button.
2 Select the Tools tab, and then select Admin Settings.
3 Select
until Network appears, and then select Network.
4 Select until Wireless appears, and then select Wireless.
5 Select until WPS Setup, and then select WPS Setup.
6 Select Push Button Control.
7 Select Start Configuration.
Ensure that the message Setting WPS is displayed, and start the WPS-PBC on the wireless LAN access point
(Registrar) within two minutes.
8 When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed.
Operator Panel
Auto SSID Setup
1 Press the (Information) button.
2 Select the Tools tab, and then select Admin Settings.
3 Select until Network appears, and then select Network.
4 Select
until Wireless appears, and then select Wireless.
5 Select until Wireless Setup Wizard appears, and then select Wireless Setup Wizard.
The printer automatically searches the access points on wireless network.
6 Select until the desired access point appears, and then select the access point.
If the desired access point does not appear, go to "Manual SSID Setup."
NOTE:
Some hidden SSID may not be displayed. If the SSID is not detected turn on SSID broadcast from the router.
7 Select Next.
8 Enter the WEP key or pass phrase.
When the encryption type of the selected access point is WEP in step 6:
Select the WEP Key text box, and then enter the WEP key.
a
Select OK.
b
When the encryption type of the selected access point is WPA, WPA2 or Mixed in step 6:
Select the Pass Phrase text box, and then enter the pass phrase.
a
Select OK.
b
9 The Restart System screen appears.
10 Turn off the printer, and turn it on again to apply the settings.
Installing Optional Accessories
61