Management Authentication Settings; Figure 65 Management Authentication Settings - Dell PowerConnect W-IAP175P User Manual

Tunnel-Medium-Type

Tunnel-Preference

Tunnel-Private-Group-Id

Tunnel-Server-Auth-Id

Tunnel-Server-Endpoint

Tunnel-Type

User-Category

User-Name

User-Vlan

Vendor-Specific


Management Authentication Settings

To authenticate the Virtual Controller Management in the Instant UI, perform the following steps:
1. Click the Settings link.
2. Select the Admins tab.
3. In the Authentication drop-down list, select any one of the following:
Internal—Select the Username and Password specified in the respective text boxes to access the Virtual

"Configuring an External RADIUS Server" on page 79
RADIUS Server—Specify one or two radius servers to authenticate UI. If two servers are configured users can

use them in primary/backup mode or load-balancing mode, this is identical to the radius server configuration
for SSIDs. For information on configuring external RADIUS server, see
page 78.
RADIUS server w/ fallback to internal—Specify the radius servers as well as a Username and Password. If

there is no response from the RADIUS server (RADIUS server timeout), the authentication will switch to
"Internal".
Figure 65
4. Click OK.
84 | Authentication
Management Authentication Settings
Management UI.
Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide
"External RADIUS Server" on