Table 9 Conditions For Adding A Guest Network-Basic Info Tab - Dell PowerConnect W-IAP175P User Manual


b. Transmit Rates: Indicates the ability to configure the basic and supported rates per SSID for Dell Instant.
Select to set the minimum and maximum legacy (non-802.11n) transmit rates for each band -2.4GHz and
5GHz.
c. Bandwidth Limits: Here, you can specify three types of bandwidth limits.



d. Band: Set the band at which the network will transmit radio signals. Available options are All, 2.4 GHz,
and 5 GHz. The All option is selected by default. It is also the recommended option.
e. Content Filtering: When enabled, all DNS requests to non-corporate domains on this wireless network
are sent to OpenDNS.
f. Hide SSID: Select this check box if you do not want the SSID (network name) to be visible to users.
g. Inactivity timeout: Indicates the time in seconds after which an idle client ages out. The minimum value
is 60 seconds and the default value is 1000 seconds.
4. Click Next. The Security tab appears. This tab allows you to configure the captive portal page for the Guest
network. Select one of the following splash page type:
Table 9
Splash Page Type
Internal—Authenticated
Internal—Acknowledged
Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide
unicast and send directly to the associated client. When Disabled, all broadcast and multicast traffic is
forwarded.
DTIM interval: Indicates the DTIM (delivery traffic indication message) period in number of beacons.
This option is configurable for each WLAN SSID profile. The default value is 1, which means the
client will check for buffered data on the IAP at every beacon. You may choose to configure a larger
DTIM value for power saving.
Percentage of Airtime: The aggregate amount of airtime that all clients on this Network can use to
send/receive data.
Each User: The throughput for any single user on this network.
Each Radio: The amount of throughput each radio (some models of AP have multiple radios) is
allowed to provide for all clients in aggregate connected to that radio.
Conditions for Adding a Guest Network—Basic Info Tab
Description and steps to set up
A user has to accept the terms and conditions and enter a username and password on
the captive portal page. If this option is selected, then add the users who are required to
use the captive portal authentication to the user database. Click the Users link to add the
users. For information about adding a user, see
information on customizing the splash page, see
page 87.
A user has to accept the terms and conditions for this splash page type.
For information on customizing the splash page, see
page 87.
"Adding a User" on page 151. For
"Customizing a Splash Page" on
"Customizing a Splash Page" on
Wireless Network | 51