Allow Pop3 Service To A Particular Server; Figure 81 Defining Rule-Allow Tcp Service To A Particular Network - Dell PowerConnect W-IAP175P User Manual

c. Select custom from the Service drop-down list.


d. Select to a network from the Destination drop-down list.


Figure 81
e. Click OK.
5. Click Finish.

Allow PoP3 service to a particular server

1. Click the New link in the Networks tab.
To define the access rule to an existing network, click the network. The edit link appears. Click the edit link
and navigate to the Access tab.
2. In the Basic Info tab, enter the appropriate information.
3. Click Next and set appropriate security levels using the slider button in the Security tab.
4. Click Next. The Access tab appears. The Allow any to all destinations access rule is enabled by default. This
rule allows traffic to all destinations. To define allow POP3 service access rule to a particular server, perform
the following steps:
1. Click New, the New Rule box appears.
2. Select Allow from the Action drop-down list.
3. Select pop3 from the Service drop-down list.
4. Select to a particular server from the Destination drop-down list and enter appropriate IP address in the
IP text box.
5. Click OK.
106 | Instant Firewall
Select TCP from the Protocol drop-down list.
Enter appropriate port number in the Port(s) text box.
Enter appropriate IP address in the IP text box.
Enter appropriate netmask in the Netmask text box.
Defining Rule—Allow TCP Service to a Particular Network
Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide