Configuring Adaptive Radio Management; Migrating From A Virtual Controller Managed Network To Mobility Controller Managed Network; Figure 49 Configuring Iap Radio Settings Mode-Access - Dell PowerConnect W-IAP175P User Manual

Instant access point 6.1.2.3-2.0.0.0
Hide thumbs Also See for PowerConnect W-IAP175P:
Table of Contents

Advertisement

Configuring Adaptive Radio Management

Adaptive Radio Management (ARM) is enabled in Dell Instant by default. However, if ARM is disabled, perform
the following steps to enable it. For more information about ARM, see
"Adaptive Radio Management" on
page 115.
1. In the Access Points tab, click the IAP for which you want to configure ARM. The edit link appears.
2. Click the edit link. An Edit AP box appears.
3. In the Edit AP box, click the Radio tab.
4. Select Adaptive radio management assigned.
Figure 49
Configuring IAP Radio Settings Mode—Access
5. Click OK.

Migrating from a Virtual Controller Managed Network to Mobility Controller Managed Network

An IAP can be provisioned as a Campus AP in a controller-based network, but a Campus AP cannot be
provisioned as an IAP. Before converting the IAP, ensure that both the IAP and controller are configured to
operate in the same regulatory domain. The reset button located on the rear of an IAP can be used to reset the
IAP to factory default settings. If you have converted your IAP to a campus AP, pressing the reset button converts
it back to an IAP. The IAP will then boot with the factory default image. Refer to the Dell PowerConnect
W-IAP92/93/105 Instant Access Point Installation Guide for details.
66 | Managing IAPs
Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect w-iap3wnPowerconnect w-series

Table of Contents