Figure 113 Throughput Graph; Table 25 Client View-Rf Trends Graphs And Monitoring Procedures - Dell PowerConnect W-IAP175P User Manual

Throughput

Figure 113
For more information about RF trends graphs in the client view and for monitoring procedures, see
Table 25
Graph Name
Signal
Frames
146 | Monitoring
Throughput Graph
Client View—RF Trends Graphs and Monitoring Procedures
Description
The Signal graph shows the signal strength of the
client for the last 15 minutes. It is measured in
decibels.
To see an enlarged view, click the graph.
The enlarged view provides Last, Minimum,

Maximum, and Average signal statistics for the
client fr the last 15 minutes.
To see the exact signal strength at a particular time,
hover the cursor over the graph line.
The Frames Graph shows the In and Out frame rate
per second for the client for the last 15 minutes. It also
shows data for the Retry In and Retry Out frames.
 Outgoing frames—Outgoing frame traffic is
displayed in green. It is shown above the median
line.
 Incoming frames—Incoming frame traffic is
displayed in blue. It is shown below the median
line.
 Retry Out—Retries for the outgoing frames is
displayed in black and is show above the median
line.
 Retry In—Retries for the incoming frames is
displayed in red and is shown below the median
line.
To see an enlarged view, click the graph.
 The enlarged view provides Last, Minimum,
Maximum, and Average statistics for the In, Out,
Retries In, and Retries Out frames.
To see the exact frames at a particular time, hover the
cursor over the graph line.
Monitoring Procedure
To monitor the signal strength of the selected
client for the last 15 minutes,
1. Log in to the Instant UI. The Virtual Controller
2. In the Clients tab, click the IP address of the
3. Study the Signal graph in the RF Trends pane.
To monitor the In and Out frame rate per second
and retry frames for the In and Out traffic, for the
last 15 minutes,
1. Log in to the Instant UI. The Virtual Controller
2. In the Clients tab, click the IP address of the
3. Study the Frames graph in the RF Trends pane.
Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide
view appears. This is the default view.
client for which you want to monitor the signal
strength. The client view appears.
For example, the graph on the left shows that
signal strength for the client is 54.0 dB at 12:23
hours.
view appears. This is the default view.
client for which you want to monitor the
frames. The client view appears.
For example, the graph on the left shows 4.0
frames per second for the client at 12:27 hours.
Table 25.