Instant Access Point View; Figure 107 Instant Access Point View - Dell PowerConnect W-IAP175P User Manual

Table 22
Graph Name
Throughput

Instant Access Point View

All IAPs in the Dell Instant network are listed in the Access Points tab. Click the IAP that you want to monitor.
Access Point view for that IAP appears.
Similar to the Virtual Controller view, the Access Point view also has three tabs: Networks, Access Points, and
Clients.
The following sections in the Instant UI provide information about the selected IAP:
Info

RF Dashboard

RF Trends

Usage Trends

Figure 107
140 | Monitoring
Network View—Graphs and Monitoring Procedures (Continued)
Description
The Throughput graph shows the throughput of the
selected network for the last 15 minutes.
 Outgoing traffic—Throughput for outgoing traffic
is displayed in green. Outgoing traffic is shown
above the median line.
 Incoming traffic—Throughput for incoming traffic
is displayed in blue. Incoming traffic is shown
below the median line.
To see an enlarged view, click the graph.
 The enlarged view provides Last, Minimum,
Maximum, and Average statistics for the incoming
and outgoing traffic throughput of the network for
the last 15 minutes.
To see the exact throughput of the selected network at
a particular time, hover the cursor over the graph line.
Instant Access Point View
Monitoring Procedure
To check the throughput of the selected network
for the last 15 minutes,
1. Log in to the Instant UI. The Virtual Controller
2. In the Networks tab, click the network for
3. Study the Throughput graph in the Usage
Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide
view appears. This is the default view.
which you want to check the client
association. The Network view appears.
Trends pane. For example, the graph on the left
shows 22.0 kbps incoming traffic throughput
for the selected network at 12:03 hours.