Job Tone
Alert Tone
All Tones
• mm / inch
Purpose:
To specify the measurement unit displayed after the numeric value on the operator panel.
Values:
Millimeters (mm)*
Inches (")
• Low Toner Alert Msg
Purpose:
To specify whether to show the alert message when the toner is low.
Values:
Off
On*
• Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 48
Values:
Yes
No*
Off
Does not emit a tone when a job is complete.
Low
Emits a tone at the specified volume when a job is complete.
Medium*
High
Off
Does not emit a tone when a problem occurs.
Low
Emits a tone at the specified volume when a problem occurs.
Medium*
High
Off
Disables all the alert tones.
Low
Sets the volume of all the alert tones at once.
Medium
High
Specifies the default measurement unit.
Does not show the alert message when the toner is low.
Shows the alert message when the toner is low.
Performs the initial settings for the printer.
Does not perform the initial settings for the printer.
Using the Operator Panel Menus and Keypad
332