Xerox DocuPrint M205 b User Manual page 131

• Using Ad Hoc Connection
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1
On the operator panel, press the
2
Select Admin Menu, and then press the
3
Select Network, and then press the
4
Select Wireless Setup, and then press the
5
Select Manual Setup, and then press the
6
Enter the SSID, and then press the
Use the numeric keypad to enter the desired value, and press the
cursor.
7
Select Ad-hoc, and then press the
8
Select an encryption type, and then press the
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
9
Enter the WEP key, and then press the
Use the numeric keypad to enter the desired value, and press the
cursor.
10
Select a transmit key.
11
Wait a few minutes until the printer restarts to establish the wireless network.
12
Print a System Settings page from the operator panel.
See "Printing a System Settings Page" on page
13
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
Auto Setup With the Access Point
If the access point such as a wireless router supports the WPS, security settings can be made
automatically.
(System) button.
button.
button.
button.
button.
button.
button.
button.
button.
182.
Printer Connection and Software Installation
or button to move a
or button to move a
130