Available Fax Setting Options - Xerox DocuPrint M205 b User Manual

Available Fax Setting Options

You can use the following setting options for configuring the fax system:
Option
Ans Select
Auto Answer Fax
Auto Ans.
TEL/FAX
Auto Ans.
Ans/FAX
Line Monitor
Ring Tone
Volume
Line Type
Dialing Type
Interval Timer
Number of Redial
Redial Delay
Junk Fax Filter
Remote Receive
Remote Rcv Tone
Send Header
307 Faxing (DocuPrint M205 f/M205 fw Only)
Description
TEL Mode Automatic fax reception is turned off. You can receive a fax by
picking up the handset of the external telephone, pressing the
remote receive code, and then pressing the
FAX Mode * Automatically receives faxes.
TEL/FAX Mode When the printer receives an incoming fax, the external
telephone rings for the time specified in Auto Ans.
TEL/FAX, and then the printer automatically receives a fax. If
an incoming call is not a fax, the printer beeps from the
internal speaker indicating that the call is a telephone call.
Ans/FAX Mode The printer can share a telephone line with an answering
machine. In this mode, the printer will monitor the fax signal
and pick up the line if there are fax tones. If the phone
communication is using serial transmission in your region, this
mode is not supported.
DRPD Mode Before using the Distinctive Ring Pattern Detection (DRPD)
option, a distinctive ring service must be installed on your
telephone line by the telephone company. After the telephone
company has provided a separate number for faxing with a
distinctive ring pattern, configure the fax setup to monitor for
that specific ring pattern.
Sets the interval at which the printer goes into the fax receive mode after receiving
an incoming call.
Sets the interval at which the printer goes into the fax receive mode after the
external telephone receives an incoming call.
Sets the interval at which the printer goes into the fax receive mode after the
external answering machine receives an incoming call.
Sets the volume of the line monitor, which audibly monitors a transmission through
the internal speaker until a connection is made.
Sets the volume of the ring tone, which indicates that an incoming call is a telephone
call through the internal speaker when Ans Select is set to TEL/FAX Mode.
Sets the line type.
Sets the dialing type.
NOTE:
• This menu is not displayed when Region is set to Australia.
Specifies the interval between transmission attempts.
Specifies the number of redial attempts to make when the destination fax number is
busy. If you enter 0, the printer will not redial.
Specifies the interval between redial attempts.
Sets whether to reject faxes sent from unwanted numbers by accepting faxes only
from the fax numbers registered in the Address Book.
Sets whether to receive a fax by pressing a remote receive code on the external
telephone.
Specifies the remote receive code in two digits to start Remote Receive.
Sets whether to print the information of sender on the header of faxes.
(Start) button.