Table of Contents
Advertisement
• Number of Redial
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the
range of 0 to 9. If you enter 0, the printer will not redial. The default is 3.
• Redial Delay
Purpose:
To specify the interval between redial attempts within the range of 1 to 15 minutes. The default is one
minute.
• Junk Fax Filter
Purpose:
To reject faxes sent from unwanted numbers by accepting faxes only from the fax numbers registered
in the Address Book.
Values:
Off*
On
NOTE:
•
Ensure to register the fax numbers you want to accept faxes from in the Address Book before using Junk
Fax Filter.
• Remote Receive
Purpose:
To receive a fax by pressing a remote receive code on the external telephone after picking up the
handset of the telephone.
Values:
Off*
On
• Remote Rcv Tone
Purpose:
To specify the remote receive code in two digits to start Remote Receive.
• Send Header
Purpose:
To print the information of sender on the header of faxes.
Values:
Off
On*
325
Using the Operator Panel Menus and Keypad
Does not reject faxes sent from unwanted numbers.
Rejects faxes sent from unwanted numbers.
Does not receive a fax by pressing a remote receive code on the
external telephone.
Receives a fax by pressing a remote receive code on the external
telephone.
Does not print the information of sender on the header of faxes.
Prints the information of sender on the header of faxes.
Advertisement
Table of Contents
