Table of Contents
Advertisement
Avoiding Jams
•
Use only recommended print media.
•
See
"Loading Print Media in the Multipurpose Feeder (MPF)" on page 150
Media in the Priority Sheet Inserter (PSI)" on page 158
•
Do not overload the print media sources. Ensure that the stacked print media does not exceed
the maximum height indicated on the paper width guides.
•
Do not load wrinkled, creased, damp, or curled print media.
•
Flex, fan, and straighten print media before you load it. If a jam occurs with print media, try
feeding one sheet at a time through the MPF or the PSI.
•
Do not use print media that you have cut or trimmed.
•
Do not mix print media sizes, weights, or types in the same print media source.
•
Ensure that the recommended print side is face up when you insert the print media.
•
Keep print media stored in an acceptable environment.
•
Do not remove the paper cover during a print job.
•
Ensure that all cables that connect to the printer are correctly attached.
•
Overtightening the guides may cause jams.
See also:
• "About Print Media" on page 138
• "Supported Print Media" on page 143
• "Print Media Storage Guidelines" on page 142
363
Troubleshooting
and
to load print media properly.
"Loading Print
Advertisement
Table of Contents
