Using The Bypass Tray - Xerox Phaser 3320DN User Manual

2. Slide the paper length guide until it lightly touches the
end of the paper stack.
3. Position the side guide by squeezing the lever and sliding
it towards the stack of paper, until it gently touches the
side of the stack.
4. Insert the paper tray into the machine.
5. After loading paper in the paper tray, set the paper size
and type using the control panel. For information about
setting the paper size and type on the control panel, refer
to Setting Paper Size and Type
6. When printing from your computer, ensure you select
Size on the driver Paper tab to specify the correct paper
size and type. Not confirming the paper details may
result in printing delays. For information about setting
the paper size and type in the printer driver, refer to
Note: The settings made from the printer driver on your computer override the settings on the
control panel.

Using the Bypass Tray

The bypass tray is located on the front of your machine. It can be closed when not in use, making the
product more compact. Use the bypass tray to print transparencies, labels, envelopes or postcards in
addition to making quick runs of paper types or sizes that are not currently loaded in the paper tray.
When using the bypass tray for special media it may be necessary to use the rear door for the output.
For further information refer to
Note: The rear door output can only be used for simplex jobs. Duplex printing with the rear door
open will cause paper jams.
Acceptable print media is plain paper from 3.0 x 5.0 inches to 8.5 x 14 inches Legal (76 mm x 127 mm
to 216 mm x 356 mm) and weighing between 16 lb and 58 lb (60 g/m² and 220 g/m²). For more media
specifications, refer to
page 119.
on page 70.
Media Output Locations
Media Guidelines and Specifications
Paper Tab on page 38.
on page 18.
on page 71 and Media Specifications
Xerox Phaser 3320DN/3320DNI
Loading Paper
on
67
User Guide