Leds Of Wgsw-404 - Planet WGSW-404 User Manual

Console
Status LEDs
10/100/1000 Mbps ports
Ports # of Ports
Console
10/100/1000
Expansion
Ports

2.2.2 LEDs of WGSW-404

The LEDs indicate the status of 10/100/1000 Mbps Ethernet ports, Over Heat, Fan Failure and Power.
The LEDs are explained in the following tables.
LED
Power
Over Heat
Fan Failure
LED
Act
FDX/COL
1000
100
10
F 2-4 F
IGURE RONT
Table 2-5 Port Function
T
ABLE
This is where you can connect to the RS-232 serial port on
1
your PC for configuring the management function.
These RJ-45 ports support network speeds of 10, 100 or 1000
4
Mbps, and can operate in full-duplex modes.
These ports provide for the installation of one or two
expansion modules that establish a Fast or Gigabit Ethernet
connection.
4
Note: You may install an 1000Base-SX, 1000Base-T or
100Base-FX expansion module and use fiber optic or
category 5 cabling.
T 2-6 P
ABLE
Color
Lights to indicate that the Switch has power.
Green
Lights to indicate that the Switch exceeds its operational
Red
temperature.
Lights to indicate that the fans are not active.
Red
T 2-7 P
ABLE
Color
Lights to indicate the Switch is actively receiving or
Green
sending the data over the port.
Lights green to indicate that the port is operating in
full-duplex mode.
Yellow
Blinks orange periodically to indicate that the connection
is experiencing collisions.
Lights to indicate that the Switch is sending or receiving
Green
data at 1000 Mbps.
Lights to indicate that the Switch is sending or receiving
Green
data at 100 Mbps.
Lights to indicate that the Switch is sending or receiving
Yellow
data at 10 Mbps.
P WGSW-404
ANEL OF
Expansion Ports
2-5 P F
ORT UNCTION
Description
S
OWER AND TATUS
Function
S LED
ORT TATUS
Function
- 9 -
LED
S
S