Rear Panel Of Wgsw-2402A; Wgsw-404 Hardware Description; Front Panel Of Wgsw-404 - Planet WGSW-404 User Manual

FDX/COL

2.1.3 Rear Panel of WGSW-2402A

The rear panel of WGSW-2402A has a power connector, a Buzzer button and a console port. Figure
2-3 shows a rear panel of the Switch. Table 2-5 explains the function of the ports shown in the Figure
2-4.
Console
Port
Power
Console
Note: To depress the Buzzer button will change the reaction of the buzzer. If the button is set to on,
the buzzer will ring as the system is under the status of overheat. Set to off, the buzzer will not
work even if the system overheats.

2.2 WGSW-404 Hardware Description

2.2.1 Front Panel of WGSW-404

The front panel of the WGSW-404 has 4 RJ-45 ports for 10/100/1000 Mbps in the middle. The port
status LEDs are indicated at the left. The expansion modules are situated at the right. Figure 2-3 shows
the Switch's front panel. Table 2-4 shows the port function of the Switch. The functionality of the LEDs
will be explained in 2.2.2 LEDs.
Lights to indicate that the port is operating in full-duplex
mode.
Yellow
Blinks periodically to indicate that the connection is
experiencing collisions.
F 2-3 R
IGURE EAR
T 2-4 P F
ABLE ORT UNCTION OF THE
This is where you will connect the AC power cord. 100~240VAC is
allowed.
This is where you will connect to the RS-232 serial port on your PC
for configuring the management function, discussed in Chapter 3.
P WGSW-2402A
ANEL OF
Buzzer Button
R
EAR
Function
- 8 -
Power
P
ANEL