Changing The Console Baud Rate - Planet WGSW-404 User Manual

F
IGURE
Use the procedures in the following sections to configure the Console Port Configuration options for
one or more ports:
To change the console baud rate, see section 4.3.3.1 "Changing the Console Baud Rate".
To change the console flow control setting, see section 4.3.3.2 "Selecting a Flow Control Method".
To enable or disable a console modem connection, see section 4.3.3.3 "Enabling or Disabling
Modem Control Options".
To specify a modem setup string, see section 4.3.3.4 "Specifying a Modem Setup String".
To enable or disable SLIP, see section 4.3.3.5 "Enabling or Disabling SLIP".
To specify a SLIP address, see section 4.3.3.6 "Specifying a SLIP Address".
To specify a SLIP subnet mask, see section 4.3.3.7 "Specifying a SLIP Subnet Mask".

4.3.3.1 Changing the Console Baud Rate

To change the console baud rate:
1. From the Console Port Configurations screen, highlight Baud Rate and press the Enter key. A
screen similar to the following shows the current console baud rate.
4-21 C P
ONSOLE ORT
- 39 -
C S
ONFIGURATIONS CREEN