Check The Leds - Planet XRT-811 User Manual

2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on XRT-811. Both
10BaseT and 100BaseT connections can be used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable.
Any LAN port on XRT-811 will automatically function as an "Uplink" port when required.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on XRT-811. Use the cable supplied
with your DSL/Cable modem. If no cable was supplied, use a standard cable.
4. Connect Printer Cable
Use a standard parallel printer cable to connect your printer to the Printer port on XRT-811.
5. Power Up
Power on the Cable or DSL modem.
Connect the supplied power adapter to XRT-811 and power up.
Use only the power adapter provided. Using a different one may cause hardware damage

6. Check the LEDs

The Power LED should be ON.
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
The WAN LED should be ON.
The Print ACT LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
Installation
7