Mdi Switch; Status Leds - Planet FNSW-1600S User Manual

Port Type Cable Type
Cat 3, 4, 5
10Base-T
Cat.5 UTP only
100Base-TX
62.5/125 m multi-mode fiber ST / SC
100Base-FX*
Table A: Supported port list

2.2.3 MDI Switch

Each numbered port of the Switch are MDI-X port, you can
direct use straight cable for the connection to your end nodes.
However, port 12/20 is with one push button. To push the button
to convert the port to MDI-II port for direct hub cascade. Please
also refer to Section "RJ-45 Pin Assignment" for more.

2.2.4 Status LEDs

One green LED to show power On/Off is on the front panel, and one
"Module Installed" LED indicator to indicate the rear open slot is
installed with a fiber-optic module. Also, each port has three status
LED indicators, as shown below.
S /
L M
TATUS
ABEL
C
OLOR
FDX
U Steady
PPER
Amber
ROW
COL
Blink
Amber
Link
M Steady
IDDLE
Green
ROW
Activity
Blink
Green
FNSW-16/2400S User's Guide
D
EANING ESCRIPTION
Lit to indicate Full-Duplex mode
detected on that port
Blinks if a collision is detected
when the port is in Half-Duplex
mode.
Lit to indicate that a valid physical
UTP/STP connection is detected
Blink to indicate the port is
receiving data packets
Connector
RJ-45
RJ-45
23 24
Reset
19 20
9